Table of Contents
The video explains the introduction to Engineering drawing and its classifications and the various instruments used in engineering drawing/graphics
This video is about the types of Lines, Dimension Styles used in engineering drawing.
This video is about the letter-writing procedure used in engineering drawing
This video explains the concept of engineering scales used in engineering drawing and their classifications.
In this video principle of diagonal scale is explained and than scale is constructed using that principle.
In this video creation of student account and installation procedure of educational version of AUTOCAD is explained.
This video explains some basic commands of AutoCAD
This video explains some advance commands of AutoCAD
This video is about the introduction of engineering drawing instruments (Click to Read In Web Form) and their uses and related queries.
This video explains the principle and construction of comparative scale
The video explains the principle and construction of vernier scale and scale of chords
This video discusses the various engineering curves and their classifications
This video explained the construction of Ellipse and Parabola using General Method
In this video special construction methods of ellipse such as concentric circle method, arc of circle method, parallelogram/oblong/rectangle method, and loop of thread method is discussed and ellipse is drawn.
This video demonstrate the construction of Parabola and Hyperbola using special methods. Tangent and Normal drawn procedure is also discussed.
In this video Involute and Cycloidal Curves are defined and their construction methods are discussed.
This video shows the Construction Method of Epi-Cycloid and Hypo-Cycloid Curves
This video explained the method of construction method of Logarithmic – Spiral Curve
Correction: The Point E on the line AC is 1.11 cm from A and not 1 cm. Apologize for the mistake
This video shows the construction method of Archimedean Spiral Curve
This video explains the method of drawing tangent and normal to Archimedean Spiral Curve
In this video Orthographic Projection, Plane of Projections, Views, and Projection Methods are discussed.
This video shows the solution of some of the problems of Orthographic Projection.
In this video Orhtographic Projections of an object are drawn in AutoCAD.
This video explain the procedure of drawing Orthographic Projections of Points
In this video projections of Straight Line is explained.
In this video problems of orthographic projections of straight lines are solved.
In this video problems on orthographic projections of straight lines are solved.
In this video problems on orthographic projections of straight lines are solved.
This video explains the Traces of Straight lines.
This video explains the concept of orthographic projections of planes
This video is about drawing Orthographic projections of planes on drawing sheet and in AutoCAD
This video is about the orthographic projections of solids
This video is about the problem solving session for Orthographic projections of solids
This video explains the concept of section of solids and solving the section of solids problems.
This video is about the construction of true shapes of section of solids.
This video is about the concept of development of solids and process to draw projections development.
Riveted Joint: Lozenge Joint Riveted Joint for Structural Use–Joints of Uniform Strength (Lozenge Joint) A…
Riveted Joint: Introduction, Classification, Strength and Efficiency of Riveted Joint Riveted Joint is a Permanent…
A knuckle joint is a hinged joint that connects two rods, typically a ball and…
Cotter joints are used to connect two rods, subjected to tensile or compressive forces along…
Basic Mechanical Properties of Engineering MaterialsIntroduction to Mechanical PropertiesMaterials are defined by their qualities. They…
Simple stresses encompass a range of fundamental mechanical phenomena, including tension, compression, shear, bearing, and…